1. Get ready to get on the bus:

1. After entering the test area, candidates should stand by the door of the vehicle cab and report to the examiner: good, examinee xx xx applied for subject 3 test. Please get ready to get on the bus.

2, candidates should start from the vehicle cab, press "left - after - right - before - left" counterclockwise around the car, carefully check the vehicle and safety conditions, and then return to the original position report: check completed. The examiners give instructions to the examinees: get in the car.

3. Upon hearing the instruction, the candidate should observe the traffic situation behind the vehicle before opening the door. After confirming the safety, the candidate should open the door to get on the vehicle. Get on the car should do: the right leg into the cab, sit down after the left leg lift into.

The examiners should examine the examinee before getting on the bus to observe, understand the surrounding environment of the vehicle, eliminate the road traffic safety hazards around, check the appearance of the vehicle, tire pressure, the process of getting on the bus and other behavior is standard.

In the examinee inspects the vehicle, returns to the driver's cab door side report inspection completes in the process, the examinee should observe examinee's manner carefully, walks, the look in the eyes, the speech expression and so on, confirms its body and the physiology condition not to have the abnormality, may issue to the examinee "please get on" the password. In case of any abnormality, the examination shall be suspended in time.

2. Starting:

(1) before starting the engine, candidates should close the door, adjust the driving seat, rearview mirror, check the instrument, fasten the seat belt, and report: "ready" after starting the engine. After the examiners have determined that it is safe, they should give the examinee an instruction: start.

(2) after the examiner approves, step on the clutch, hang a gear, play the left light, sound the horn, look in the left mirror, and let the hand brake go. If there is a car behind you, you can go straight for a period of time and then parallel line. Start to do "a step on clutch, two gear, three dozen steering, four sound, five look at the rear mirror, six loose brake, slow lift clutch, light fuel; Move to second gear.

The examinee must in the examinee starts the instruction to be able to start.

Started atpe assessment to examine the candidates before the start of the formation of traffic safety consciousness, pay attention to observe the behavior of candidates before the start whether conform to the requirement of the project, timely discover and correct the examinee not fasten your safety belt, the rearview mirror not adjust good start, start braking pressure is insufficient, the door not closed off, not through the rearview mirror and head to the left side, observing the left rear traffic conditions, etc.

3. Driving in a straight line:

In the assessment of driving in a straight line, the examiners should issue "driving in a straight line" instruction according to the road traffic conditions, to assess whether the examinee can keep the vehicle in a straight line and whether the attention is evenly distributed.

Candidates in the process of driving in a straight line to ensure that with the car safety speed and distance, to understand the speed of the vehicle, pay attention to observe the road conditions, take appropriate measures. Can not swing from side to side, instability in the direction of the phenomenon.

Gear up according to road conditions. Generally three to four gear is ok, if the road conditions are ideal, add to five gear is also ok, but remember, must control the speed, do not exceed 50. Villages, schools, crosswalks and bus stops must slow down! If it's third gear, ease the throttle, and if it's fourth or fifth gear, tap the brake. Have again, remember namely, should every every about 20 seconds look or so rearview mirror, otherwise catch severe word to be able to be deducted 10 minutes.

Upgrade mark: one liter two (10 km); Two liters (three kilometers); Three liters (four kilometers); Four liters (40 kilometers).

Gear reduction marks: five minus four (30km), four minus three (25km), three minus two (20km) and two minus one (10km).

4. Lane change:

When the test vehicle is driving on more than two motor vehicle lanes in the same direction, the test staff should issue the "lane change" instruction timely according to the road traffic conditions. Candidates in the implementation of lane change instructions, through the internal and external rearview mirror to observe the situation of the rear road, observation action to be reasonable and effective.

The examiners should pay attention to the rationality of the line of sight transfer of examinees and focus on the cultivation of safety awareness of examinees when changing lanes.

5. Crossing the intersection:

When the vehicle runs into the road ahead, the test staff should give the "pass the road" command to the examinee 150 meters away from the road. In the process of driving the vehicle, the examinee should understand and master the rights and obligations of giving priority to traffic and giving way, and use it accurately. Remember to pull the handbrake and return to neutral when you stop at a red light. When passing the intersection, the examinee should slow down, sound the horn and make the obvious side head movement which the left, the right observes, observes the surrounding situation accurately.

The test examines the examinee when passes the intersection to observe the traffic safety laws and regulations the consciousness and the security, observes the examinee before crossing the intersection, decelerates, the observation driving ability.

6, through the crosswalk line, through the school area, through the bus stop:

Vehicle in case of the pavement, school area, bus stops, atpe in 150 meters from the above-mentioned places outgoing candidates respectively issued "through the crosswalk line", "through the school area", "by the bus stop" three instructions, examinee when performing the above three instructions, to slow down, sound horn, and made the action of about observation and it comes to the pedestrian crossing pedestrian crossing, should stop to give way. The examinee must carry out the safe driving principle strictly, achieves the attention even distribution, the line of sight reasonable transfer.

The examinee will be assessed whether he/she will slow down and observe left and right side of the road when driving on the above road section, especially whether he/she will stop to give way when a pedestrian passes the crosswalk, and observe whether the examinee's attention is evenly distributed and his/her line of sight is reasonably shifted.

7. Meeting:

When the vehicle is driving on the road without central isolation or Central Line, the examinee will give the instruction of "meeting the vehicle", the examinee should strictly abide by the traffic safety laws and regulations, and drive in a civilized manner. In the process of meeting, maintain a safe horizontal spacing.

The test examines the examinee to observe the traffic safety laws and regulations the provision, the civilized driving, the civilized comity professional ethics and judges in the meeting process both sides vehicle maintains the crosswise safe distance the skill.

8. Overtaking:

When there is a vehicle driving at a low speed in front of you, when the road is in good condition, the examinee will issue the "overtaking" command. The examinee should observe the traffic situation at the rear and the left through the internal and external rearview mirrors, and accurately select the overtaking time, the safe distance between overtaking and the vehicle to be overtaken, so as to ensure the safety of overtaking.

The examination examinee whether achieves in the overtaking process the line of sight reasonable shift, conforms to the stipulation, safe driving and so on.

9. Turn around:

When there is a u-turn sign on the test section in front of you, the test staff should fully observe the traffic coming from the opposite lane and issue the "u-turn" command at the right time. The test taker should accurately select the u-turn time and location based on the principle of safe driving and should not obstruct the passage of other vehicles and pedestrians.

Remember to turn left when you see the turn signal (the rule is to turn on the light within 100 meters to 50 meters, better early than late). Speed down to the first gear before the turning point, pay attention to the left mirror to observe the rear car situation, but also pay attention to the opposite car situation, pay attention not to rush, if the lane is narrow, you can hit a right, then left to kill, so as not to touch the edge of the road, turn back after the positive.

Focus on the test candidates to choose the appropriate time and location for u-turn.

10. Pull over and park:

(1) after fulfilling the specified test project, atpe issued a "pull over" instruction, the examinee after hearing the order to stop, be sure to play the right light, at the right rear view mirror (should have clear head movement, should not be mistaken for a look at the mirror), observe the surrounding environment, to determine the parking place, after parking the vehicle road edge line on the right or the pavement edge distance to conform to specified requirements.

(2) the first shake handshandle after parking brake to go back to gap, will turn back is and the engine flameout, you look at the left rear view mirror in the car to open the door (do side head movements), to observe the suitability and the left side of the traffic conditions and pushed the door and get off, get off and shut the doors on the side of the road at night when parking to close the warning lights headlamps, open, completes the safety protection measures, so as to avoid an accident.

The examination examinee in the parking process, whether violates the traffic safety laws and regulations the parking regulation, before the examination stops the examinee's line of sight reasonable shift, the examination examinee in the parking process operation skill whether conforms to the request.

11. Night driving:

During the night driving test, the main test is whether the examinee can comply with the provisions of the road traffic safety law and the implementation regulations, and whether the light can be turned on and used correctly.

Candidates should be familiar with the laws and regulations related to driving at night, and master the skills of correctly turning on and using lights.